© 2015-2019 by Melanie Spinks. All world rights reserved. Image copyrights are registered.

  • w-facebook
  • LinkedIn Clean

© 2015-2019 by Melanie Spinks. All world rights reserved. Image copyrights are registered.

Search
  • Melanie Spinks

Using the Lathe to Clean Up Your Castings


Casting metals is a lot of work but with rewarding result. You foundry buffs know that clean up is a large part of the work, especially if you are going for precision geometrics. But master craft, James, let me in on a way to use the lathe for clean up that yeilded a quick, consistent finish.

Allow me to give a word of appropriate warning. The lathe can be one of the most dangerous pieces of equipment in the shop. Use with adequate training and healthy fear. In general, I'm highly cautious of things that spin.

Our team started with a 3D printed model from an engineering print. From there master sculptor Josh made our

I then cut the sprews away using an angle grinder, chipping

the remaining shell away with hammer and chisel. A 4" belt sander and 5" orbital leveled out the sprews and vents. So far so good, but now the job of taking the finish down to a fine consistent smooth (and even) model.

This is where James stepped in and placed the piece on a lathe. This is actually a wood lathe modified for metal

work. A wooden mandrel used for spins was placed in the large end a block of shaped acrylic in the smaller to lock the bell in

place. He's demonstrating in the pict below how on relatively slow speed, a file over the surface quickly clears

away the rough outer layer. After that, sand paper finished the work, beginning with 80 grit taking the piece down to 220 sufficient for our craftsman to fit the piece into the finished custom form.

Below is the complete brass, ready for patination.

#shoptalk #casting #lathe #blogroll

16 views

M. Spinks Art